Best Concrete & Masonry Anchors (2026)
By The DIYPicks Team · Updated July 2026
DIYPicks is reader-supported. As an Amazon Associate and affiliate of home-improvement retailers, we may earn a commission when you buy through links on our site — at no extra cost to you. This never affects our recommendations.
Concrete, brick, and block each behave differently, so the right anchor depends on the base material as much as the load. We picked a removable screw anchor, a structural wedge for solid concrete, and a sleeve anchor that also works in brick and block. All three need a hammer drill.
The easiest, most forgiving way to fasten light-to-medium items to masonry, but not a structural anchor.
- Concrete
- Brick
- Light to medium loads
Pros
- No separate plug or expansion sleeve, the screw threads directly into the drilled hole
- Removable and repositionable, unlike wedge or sleeve anchors
- Free correctly-sized carbide bit is included in the box, and Climaseal coating resists corrosion
Cons
- Hole depth and diameter must be exact or the screw strips and loses grip
- Much lower pull-out than a wedge anchor, not for structural or vibrating loads
- Needs a hammer drill for anything but the softest block, and dust must be cleared from the hole
The go-to structural anchor for solid concrete, but permanent and wrong for hollow or brittle masonry.
- Concrete
- Heavy loads
- Structural
Pros
- Highest holding strength here for solid concrete, code-listed for structural use
- Simple install, drill, hammer in, tighten the nut and the sleeve expands to lock
- Zinc-plated steel stud handles high shear as well as tension loads
Cons
- Permanent, once expanded it cannot be backed out and reused
- Only for solid concrete, it will crack or fail to hold in brick, block, or mortar
- Requires a hammer drill and correct embedment depth and edge spacing to reach rated capacity
A versatile expansion anchor that works in brick and block where wedge anchors fail, at the cost of some peak strength.
- Brick
- Block
- Concrete
Pros
- One of the few expansion anchors rated for brick and hollow block, not just poured concrete
- The full-length sleeve spreads clamping force, so it is more forgiving in soft masonry than a wedge
- Code-approved for commercial building use and available in many lengths
Cons
- Lower ultimate strength than a wedge anchor of the same diameter in solid concrete
- Permanent and not reusable once the sleeve expands
- Holding power in old or crumbly brick is unpredictable and should be pull-tested
Still deciding? Compare them
Frequently Asked Questions
- Can I use a concrete wedge anchor in brick?
- No. Wedge anchors are for solid poured concrete only and can crack brick or fail to grip in mortar. Use a sleeve anchor or a Tapcon screw for brick and hollow block instead.
- Do I need a hammer drill for these?
- Yes for concrete and hard block. A regular drill will not clear the hole in solid concrete, and the hole diameter and depth must be exact for the anchor to reach its rated hold.