Best Table Saw Blades for 2026
By The DIYPicks Team · Updated July 2026
DIYPicks is reader-supported. As an Amazon Associate and affiliate of home-improvement retailers, we may earn a commission when you buy through links on our site — at no extra cost to you. This never affects our recommendations.
A table saw is only as good as the blade on the arbor. For most DIYers a single 40-tooth combination blade handles both ripping and crosscutting, but adding an 80-tooth finish blade transforms cut quality on sheet goods and hardwood. Here are the two blades that cover almost every table saw job.
The default do-everything table saw blade: a 40-tooth combination grind that rips lumber and crosscuts sheet goods well enough that most DIYers leave it mounted year-round.
- Ripping
- General purpose
- Crosscut
Pros
- 40-tooth ATB grind rips and crosscuts acceptably, so you rarely swap blades for general shop work
- TiCo carbide holds an edge far longer than budget blades and can be resharpened several times
- Perma-Shield non-stick coating resists pitch buildup and gum, keeping cuts cooler under load
Cons
- 40 teeth leave a coarser edge than a dedicated 80T crosscut blade on trim and plywood veneers
- Full 0.098 in kerf wastes more material and asks more of underpowered contractor saws than a thin-kerf blade
- ATB teeth chip melamine and double-sided laminate unless you score first or add a zero-clearance insert
A dedicated fine-finish crosscut blade: 80 alternating-bevel teeth deliver the cleanest possible edge on a miter saw for trim carpentry and cabinetry, at the cost of ripping ability.
- Fine crosscut
- Trim molding
- Crosscut
Pros
- 80 Hi-ATB teeth leave a near-sanded edge on hardwood, molding and veneered plywood with almost no tearout
- High tooth count cuts melamine and paneling cleanly with minimal chipping on the show face
- Perma-Shield coating and thin plate reduce grabbing and burning on slow, controlled miter cuts
Cons
- 80 teeth clog and burn if you try to rip solid stock or feed thick material fast
- More teeth mean a slower cut and more heat, so it is the wrong blade for framing or rough demolition
- Fine tips are easy to chip on hidden nails or staples, and resharpening 80 teeth costs more than a 40T
Still deciding? Compare them
Frequently Asked Questions
- What tooth count should a general-purpose table saw blade have?
- A 40-tooth ATB combination blade is the sweet spot: enough teeth to crosscut cleanly but few enough to rip solid lumber without burning. Drop to 24 teeth for fast ripping or jump to 80 teeth for the finest crosscuts.
- Should I use a thin-kerf or full-kerf blade?
- Thin-kerf blades waste less wood and are easier on underpowered contractor and jobsite saws. Full-kerf blades like the D1040X are more rigid and track straighter on cabinet saws with 3+ HP. Match the kerf to your saw's power.