Diablo D0760A 7-1/4 in. 60-Tooth Ultra Finish Saw Blade Review (2026)
By The DIYPicks Team · Updated July 2026
DIYPicks is reader-supported. As an Amazon Associate and affiliate of home-improvement retailers, we may earn a commission when you buy through links on our site — at no extra cost to you. This never affects our recommendations.
- Fine finish
- Crosscut
- Trim
- Plywood
- Melamine
The Diablo D0760A is a 60-tooth ATB ultra-finish blade for 7-1/4 in circular saws, built for the cleanest cut when the edge will show. Its thin 0.059 in kerf, TiCo Hi-Density carbide teeth and Perma-SHIELD coating deliver near-sanded crosscuts in oak, pine, veneer plywood and melamine. Best reserved for finish cuts - it is slower and burns more easily than a 40-tooth blade in thick or rip work.
Pros
- Leaves a glass-smooth, chip-free edge that needs little or no sanding
- Perma-SHIELD non-stick coating resists heat, pitch and gum buildup
- Thin 0.059 in laser-cut kerf eases the load on cordless and lower-power saws
Cons
- 60 teeth cut slowly and can burn in thick or rip cuts
- Small gullets clog quickly in resinous or wet stock
- Dulls fast and is overkill for rough framing or nail-embedded wood
Specifications
| Teeth | 60T ATB |
|---|---|
| Arbor | 5/8 in (diamond knockout) |
| Kerf | 0.059 in (thin) |
| Material | TiCo Hi-Density carbide |
| Diameter | 7-1/4 in |
| Max RPM | 8000 |
| Best cut | Ultra-fine crosscut / trim / plywood / melamine |