Diablo D1024X 10 in. 24-Tooth Ripping Saw Blade Review (2026)
By The DIYPicks Team · Updated July 2026
DIYPicks is reader-supported. As an Amazon Associate and affiliate of home-improvement retailers, we may earn a commission when you buy through links on our site — at no extra cost to you. This never affects our recommendations.
- Ripping
- Hardwood
- Thick stock
The Diablo D1024X is a 10 in, 24-tooth dedicated rip blade for table saws, built to power through thick hardwood, plywood and OSB. Deep gullets and a 15-degree hook feed aggressively so the motor never bogs, while TiCo carbide and Perma-SHIELD coating hold up to heat and pitch on long rips. It is a specialist: fast and clean along the grain, but the coarse grind and full kerf make it a poor crosscut or sheet-good blade.
Pros
- 24-tooth deep-gullet grind rips thick hardwood fast without bogging the saw
- Aggressive 15-degree hook angle feeds smoothly through dense stock
- Perma-SHIELD coating resists pitch and heat on long rips
Cons
- 24 teeth leave saw marks that need cleanup on finish edges
- Poor for crosscutting - it tears out veneer and melamine
- Full 0.098 in kerf wastes more wood and taxes lower-power saws
Specifications
| Teeth | 24T ATB |
|---|---|
| Diameter | 10 in |
| Arbor | 5/8 in |
| Kerf | 0.098 in (full) |
| Hook angle | 15 deg |
| Material | TiCo Hi-Density carbide |
| Best for | Fast rip cuts (3/4 - 2-3/4 in) in solid lumber, plywood and OSB |